Abrasive solutions for technical materials
From trimming to finishing, Extrom supports professionals in selecting abrasive solutions for processing composites and plastics.
Fibreglass, carbon fibre, resins, gelcoats, laminates or synthetic materials: we select the abrasive technology, grit and backing according to the material, equipment used and desired result.
ABRASIVE SOLUTIONS
FOR EVERY APPLICATION...
- Cutting and trimming
- Edge deburring
- Sanding and surface defect correction
- Preparation before bonding, painting or coating
- Finishing and polishing
- Solutions for heat-sensitive materials
- Custom manufacturing and converting
- Personalised technical advice
Our solutions for composites and plastics
From trimming to finishing, every stage of composite and plastic processing requires a solution adapted to the material, equipment used and desired result.
Cut and trim
Achieve precise cutting and trimming of composite and plastic parts with solutions adapted to the material.
Deburr and finish edges
Remove burrs and finish edges after cutting or machining while maintaining the required surface quality.
Sanding
Sand and even out surfaces with abrasives suited to composites, resins and plastic materials.
Correct surface defects
Correct irregularities and surface defects before the next preparation or finishing stages.
Prepare before painting and coating
Prepare surfaces before bonding, painting or coating to achieve a suitable surface for the next stage.
Finish and polish
Achieve the required finish with solutions adapted to the material and desired surface quality.
Solutions adapted to every composite and plastic
Carbon fibre, fibreglass, resins, gelcoats, laminates and plastics each have specific characteristics. The choice of abrasive, grit, backing and technology depends on the material, operation and required finish.
CARBON FIBRE
Solutions for cutting, trimming, deburring and finishing carbon fibre reinforced composites.
FIBREGLASS
Abrasive solutions for processing fibreglass reinforced composites, from trimming and sanding to finishing.
RESINS, GELCOATS & LAMINATES
Solutions for sanding, correcting defects, preparing and finishing resins, gelcoats and laminated surfaces.
PLASTICS & SYNTHETIC MATERIALS
Solutions for sanding, deburring and finishing plastics and other synthetic materials.
A wide range of solutions
for composites and plastics
Extrom offers a selection of abrasive and polishing solutions for composites and plastics, from cutting and surface preparation through to finishing.
Sanding abrasives
Abrasive solutions for sanding composites and plastics, from surface preparation through to fine sanding operations.
Cutting & deburring
Solutions for cutting, trimming and deburring composites and plastics, including fibre-reinforced materials.
Finishing abrasives
Fine abrasives and non-woven solutions for surface preparation and finishing, providing progressive and controlled processing.
Polishing products & accessories
Products, foam pads, felts and accessories for polishing composites and plastics to achieve the required finish.
Expertise & support
More than an abrasive, a solution tailored to your process
Working with composites and plastics requires consideration of the material, its structure, the equipment used and the required finish.
Our team helps you select the right abrasives and solutions for your application, from cutting and deburring to sanding, surface preparation, polishing and finishing.
Need a solutionfor composites and plastics?
Our team advises you on selecting the solution best suited to your material, equipment and application.
